HealthLab Battery Pack AP-5002

HealthLab Battery Pack AP-5002

The HealthLab Battery Pack AP-5002 is used for the realisation of longer measurement durations with the HealthLab monitoring system under maintaining of the mobility of the proband. The device is connected to the USB Interface of the Heally Master (e.g. HealthLab HFM-01) and supports in this way an additional voltage supply of the master, as well as of the connected satellites. By actuating the switch-on- and battery-check-button (CHECK / ON), the AP-5002 is activated, respective the state of charge of the device is checked (at low capacity only the right LED lights, when fully charged all four LED lights). If no current (I < 20 mA) is obtained from the battery over a period of more than 60 seconds, the device
automatically turns itself off. On critical errors, e.g. a short circuit at the voltage output, the AP-5002 turns off. By means of the reset button at the top edge of the device, it can be reactivated.

Note: On initial commissioning, the unit is to be charged for the duration of 8 hours, after that, charging is performed as required.
Attention: While the AP-5002 is connected to the HealthLab measuring system, the battery pack must not be charged (observe the hints on the backside of the device)!

Links on further documents:
• Hardware: Master HFM-01
• Software: Heally Control

Back to overview


Designation HealthLab Battery Pack AP-5002,
external voltage supply
Type of Battery lithium polymer accumulator
Battery Capacity at 5 V DC approx. 1.200 mAh
Nominal Input-Voltage / -Current 5 V DC / max. 500 mA
Nominal Output-Voltage / -Current: 5 V DC / max. 500 mA
Climatic Conditions acc. to DIN EN 60204-1 ( 10-2014 )
Ambient Temperature operation: -20 … +55 °C
transport / storage: -25 … +60 °C
Humidity / Altitude 20 … 90 % RH ( without condensation )
up to 8.000 m
Dimensions W / H / D : 84 x 58 x13 mm
( without wiring )
weight : 71 g
Download PDF

db Datasheet

Ordering Information AP-5002 HL Battery Pack: